Car - 1/10 XL Electric - 4WD Truggy - RTR - HRC NEOXX - Brushed - ARTEMIX V2 RED/BLACK
The NEOXX V2 ARTEMIX from HRC RACING is an all-wheel drive 4WD RACING TRUGGY in 1:10 XL scale.
The NEOXX V2 models from HRC RACING have two large bumpers at the front and rear. With LED lights installed in the front and rear bumpers, night becomes day! The bodywork is made of robust Lexan polycarbonate.
The model is splash-proof for driving fun in all weather conditions!
The internal components are supported by a robust base plate made of high-quality aluminium.
3 adjustable oil differentials ensure optimum power distribution between the front and rear axles and improved traction. With the differential function, the driving behaviour can be adjusted to be milder or more aggressive as required.
Encapsulated transmission components reduce stone chipping and the risk of injury.
At the front axle, the bone has been connected to the wheel axle to form a universal CVD drive shaft. This allows more steering angle and ensures less friction loss. In addition, the bone is no longer lost in the event of hard impacts.
Adjustable oil pressure shock absorbers ensure good damping when jumping and cornering.
A wall on the side of the chassis plate allows less dirt to enter the vehicle.
The model is equipped with energy-saving ball bearings. High-quality tyres with high traction give the model very good grip on any surface.
To ensure a long service life and high performance, the HRC NEOXX V2 models are fitted with electronic components from well-known brands. A high voltage level and a high capacity of the supplied batteries ensure maximum acceleration and top speed in addition to a longer driving time.
The complete RTR set is supplied with the 2.4 GhZ NEOXX FS-G4P transmitter from HRC RACING. The transmitter has all the important trim controls and 4 channels. Optionally, LEDs or winches, for example, can be controlled via the free channel 4.
With the 220V quick charger, batteries can be recharged within a short time.
The speed controller, batteries and charger are equipped with new custom-fit XT60 high-performance plugs.
Specifications NEOXX V2 (Brushed):
- 1/10 XL wheelbase 300mm
- Overall length 460mm
- Large XL front and rear bumpers
- Bodywork made from robust Lexan polycarbonate
- LED lights front and rear
- Splash-proof onboard electronics
- 3 differentials (front, centre, rear) for improved traction
- Aluminium floor plate
- Adjustable oil pressure shock absorbers
- Encapsulated gearbox
- Dirt deflector on chassis plate
- Engine heat sink for improved heat dissipation
- Low friction ball bearings
- 2.4GhZ NEOXX 4CH transmitter from HRC RACING
- 2.4GhZ NEOXX 4CH receiver from HRC RACING
- Optional control of LEDs and cable winches
- HRC RACING 40A/180A controller (XT60 plug)
- HRC RACING brush motor 550
- Splash-proof on-board electronics
- HRC RACING 7.2V 4000 NiMH battery
- HRC RACING quick charger
- Maximum speed: 30 KM/H
Information and appendices are subject to typographical errors, photographs and texts are noncontractual. The contents of this site are subjected to copyright.
Manual - HRC NEOXX V2.0 Manual DE, FR, EN + Exploded View (9.55 Mo)
